In case of problems with the Park-Position it is possible to automatically reposition the Mover at the correct location:

• Initially ensure that both the Stage and the Mover are switched off.
  
  
• Switch on the mover:
  => The left green LED indicates an active power supply
  
  
• It is now crucial to wait for the software of the Mover to establish its network connection:
  => The white LED in the middle will light up, as soon as the communication with the corpus.e server was successful.
  
  
• Next make sure that the Mover is located at least close to the Park-Position or on the usual circular path during scanning.
  
  
• Finally switch the Stage on again:
  If the Mover should not be detected in the required Park-Position the Stage will start a rotation of the internal magnet
  in order to “catch” the mover and transport it back to the Park-Position
  
  
• At the end of this rotation the magnet will stop itself and thus the Mover at the Park-Position:
  => The outer white LED will indicate exactly this.