If the camera called “Mover” does not make a clean lap, please note the following:

• Make sure you put the scan plate on a flat and even surface. Do not put the scan plate on a carpet!

• Make sure the scan plate is not standing on a cable etc.

• Make sure you are using the provided power supply cable "MEANWELL" Output: 18V / 2A / 36W

• Make sure the power supply cable is firm in the socket and the power LED on the scan plate is shining continuously and stable

• Do not connect other large power consumers to the same power supply

• Has anything changed before Mover driving problems occurred?

• Has the stage been stored and recently reassembled?

• Was it stored upright?

• Was the drive belt inside the scan plate ever exchanged? You can see a small part of the drive belt when you take a close look at the park position

  → old belt = all black

  → new belt = white / green
  
  

• Does the Mover have permanent contact with the magnets during the lap and also when back at the park position?

• Are you using a custom built frame around the scan plate?

• Make sure the frame does not press on the sides of the scan plate

• Do not put the scan plate directly on a floor heating system

• Are you sure the metal top cover plate is firm on the scan plate and it is not loose at any spot?